.410 Front and Rear Sling Adapter

Description

How to Install

Front Barrel Clamp Attachment:

1. There are 4 pieces to the front attachment that clamps around the barrel

1. 1. Two round clamps
   2. One regular Allen key screw
   3. One hollow slotted screw
2. The flat portion of the rounded clamp pieces fit flush together.  The smaller hole on the upper side is where the small Allen key screw goes in.  Form the rounded clamp round the barrel and insert the screw on the side that is slightly indented and NON-threaded.  Then screw it into the other side until it stops.
3. The clamp may still be loose on the barrel.  Insert the hollow slotted screw in the OPPOSITE side in the larger hole.  Tighten that screw with a flat head screwdriver to provide leverage on the clamp and tighten into place on the barrel.
4. To mount the sling in the front connection, unscrew the hand nut on the sling until it stops.  Push it inward to release the sling connector post and turn until post is free.
5. Feed the post through the hollow screw and reconnect the post through the hole in the sling atttachment.  Tighten the hand nut until tight.

Rear Attachment:

1. The rear attachment is meant to be held by screwing into the stock.
2. Use a 3/16″ drill bit to drill a hole into the stock.
3. Screw the rear sling adapter into the stock until tight.
4. Install the rear sling attachment to the adapter using the same steps as 4 and 5 in the above instructions.